I’ve been busy working on a Master Bedroom makeover. It is badly in need of some TLC, as you will see when I finally share some “before and afters” of the entire space after this project is completed. For now, I am sharing a small makeover of 2 chairs we have in the room.
“Before”
I used bleached Painters Drop Cloths to cover the seats of these chairs
(for a tutorial on how to bleach and soften drop cloth, go HERE)
Start by laying your seat on your fabric and cut at least a 4” border all around it.
Make sure the “right side” of your seat and the ”wrong side” of your fabric are facing each other before you adhere the fabric to the seat.
I used a small staple gun for this project but a glue gun will do the job just as well.
Start by folding one edge of fabric over and stapling it to the wood. It helps to lay your seat on a hard surface and use firm, even pressure as you staple. I staple every 3 inches or so. Next, staple the opposite side of the seat and be sure to pull your fabric “taught” before stapling.
Now you’re ready for the other 2 “sides” of the seat and your “corner folds.” Fold the fabric over and cut a small portion of the fabric out. It can be a bit “bulky” otherwise.
Now fold the fabric as you would when wrapping a present. Staple where you would normally use “tape.” Repeat this step for all 4 corners of your seat.
I decided to paint & hand stencil a design onto my seat cushion but there are many “transfer methods” out there if you choose to transfer an existing image.
The Graphics Fairy has an unlimited array of gorgeous images and tutorials on how to transfer to fabric so please check her out!
~*~ Painted Seat Cushion Tutorial~*~
~ Paint: I used an interior latex paint in a satin finish: "Cathedral Stone" by Valspar
~ Stencil: This one is made by “Stencil Ease” found at A.C. Moore
I wanted to give my seat cushion a French Grain Sack look.
First, I decided the width I wanted for my “middle line”, which would be the largest of all the lines (1” w). I then measured the width of my seat, found the center point and used masking tape to tape off my line.
~*~Be sure to press the tape firmly onto the fabric so the paint does not “bleed” under it while you are painting.
Time to paint! I
used a small foam brush. Dip the brush into the paint and “blot” on several sheets of paper towel.
~*~You can always go back and make your line darker but you can't go back and make it lighter...right?
Let dry completely and pull off your tape.
For the next lines, I decided on the “width” (1/4”) and then measured, taped and painted as I did for my first line.
I loved the way the cushion looked with just the painted lines but wanted to add a simple embellishment so I decided on a French-inspired stencil. I think a number or monogram would look lovely as well.
I taped my stencil onto the fabric and used the foam brush to fill it in.
~*~Again...use light paint on your brush and go over it if you prefer a darker pattern. Let dry and remove stencil.
Ouila!
And here are some “afters”...
~ I painted the chair in “Bone White”
by Ben Moore ~
Do “stay tuned” as I will be sharing more DIY projects from my “Master Makeover.”
(Hey LoMo...if you're reading this, I hope you’re feeling better! ;)
